With you will erase configuration file in flash startup-configuration.Įrase configuration in flash memory? Verify there is a valid image on disk0:/ or the system will not boot. The first image found in disk0:/ will be used to boot the system on the next reload. Note: The boot system configuration will be cleared. ![]() You will get configured DHCP Server configured for INSIDE hosts, all interfaces will be in vlan 1, OUTSIDE interface vlan 2 will be set with command, you will get object network, configured with NAT, ACL etc. If your goal is to have ASA configured just like out of box from Cisco go with Clear configuration file to the basic configuration of ASA. Which one to use, well, both does their job quite good. Hostname or A.B.C.D Specify optional management interface IP address ![]() There is option for configure factory-default command: There are multiple different ways to do that but I prefer this two ways to clear my configuration from ASA.įirst and second
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |